Hello friends, in today's article I will share some necessary delete commands for you. Most people can do configuration but many don't know how to default configuration or delete the configuration. Many times we forget the command which command to delete which configuration. That's why today's article. You may want to note down these commands somewhere for convenience. So let's get started.
ALL Delete/No Commands:
Below is a very nice description of BDCOM OLT/Switch DELETE or NO commands. It also mentions what a command does and what it is used for. Hope you will benefit a lot.
1. This command can be used to turn on or open a port if it is closed.
sw_config_g0/2#no shutdown
2. This command is used to delete an IP address from a port or VLAN interface.
sw_config_v100#no ip address
3. This command is used to delete a specific default route.
sw_config#no ip route default 10.202.3.5
4. This command is used to delete all VLANs from a specific port.
sw_config_tg1/4#no switchport trunk vlan-allowed
5. This command is used to set a specific port to default mode.
sw_config_tg1/3#no switchport mode
6. This command is used to delete the description of a specific port.
sw_config_tg1/2#no description
7. This command is used to delete a VLAN.
sw_config#no vlan 120
8. This command is used to delete the spanning tree.
sw_config#no spanning tree -
9. This command is used to delete an Access VLAN from a specific port.
sw_config_g0/14#no switchport pvid 600
10. This command is used to delete all previous configurations on a specific port.
sw_config#default interface gigaEthernet 0/2
11. This command is used to delete upload and download configuration on a port.
sw_config_g0/10#no switchport rate-limit ingress & no switchport rate-limit egress.
12. This command is used to delete the bandwidth limit configuration on a port.
sw_config_g0/11#no speed
13. This command is used if a port has half duplex or full duplex configuration to be deleted.
sw_config_g0/11#no duplex
14. This command is used to disable any port loop detect configuration.
sw_config_g0/11#no loopback-detection enable
15. This command is used to delete user access.
sw_config#no username rakib
16. This command is used to delete the hostname of a device.
sw_config#no hostname
17. This command is used to delete the device's enabled password.
sw_config#no enable password
18. This command is used to delete LACP or Bonding.
sw_config#no interface port-aggregator1
Conclusion:
Above is the command to delete the important configuration of BDCOM OLT and switch. Hope everyone understands. If anyone doesn't understand then comment. I will try to support everyone.