Hello, friends today we will learn a very simple topic. We all know how to trunk ports on Cisco and BDCOM switches. But today we will learn how to trunk port of Huawei switch. Also, there is how to add all VLANs to the port by trunking the port. Without further ado let's get to the configuration.
Step By Step Configuration:-
Follow the command below to configure the Huawei Switch port.
Step 1 Goto config mode:
<HUAWEI-SW>system-view
Step 2 Select Interface:
[HUAWEI-SW] interface GigabitEthernet 0/0/10
Step 3 Set Type of Port:
[HUAWEI-SW-interface GigabitEthernet 0/0/10]port link-type trunk
Step 4 Allow all VLANs:
[HUAWEI-SW-interface GigabitEthernet 0/0/10]port trunk allow-pass VLAN all
Or allow Specific VLANs:
[HUAWEI-SW-interface GigabitEthernet 0/0/10]port trunk allow-pass VLAN 200
Step 5 For Exit:
[HUAWEI-SW-interface GigabitEthernet 0/0/10]quit
If anyone has a problem understanding then comment in the comment box. I will try to support you. If you like the post, don't forget to share it with your friends. Thanks.